Product Description: the transparent crystal heat insulation film has a light transmittance of more than 70% and a heat insulation effect of more than 80%
instructions:
1. Clean and dry the glass surface before spraying; Stick the window frame and other parts with masking paper to avoid adhering paint.
2. Shake the tank up and down for about 1 minute to fully and evenly mix the paint.
3. Put a piece of white paper next to the glass, first press the spray can against the white paper to stabilize the sprayed paint mist pressure, then control the spray can 20-30cm away from the glass and spray it evenly for about 2-3 times until the thickness is uniform and transparent.
4. Note that the spraying of glass on the same side shall be completed at one time, and the can spraying button shall not be released halfway.
5. If the appearance is affected by uneven hanging and spraying, the film can be cleaned with a wet cloth stained with 75% alcohol. After the glass surface is dry, the product can be used for spraying again;
matters needing attention:
1. This product is a pressure vessel and should be stored in a cool place with a temperature of < 35 ℃.
2. Avoid open fire, puncture, impact, extrusion, freezing or burning the tank.
3. When using this product, you should wear masks, goggles, gloves, etc. for protection. If you touch it by mistake, you can wash it with alcohol;
4. This product shall not be eaten. It has a slight taste when spraying and is tasteless after drying.
5. If the product is accidentally splashed on the mouth, eyes and other parts during the use of this product, wash it with a large amount of water immediately. Those who feel serious or uncomfortable should go to the hospital for treatment.
6. The light transmission and heat insulation effect of this product is affected by the glass body and spraying method according to the data reported by the testing organization.
